Re-Ptx-X8-128G Routing Engine Components - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

NOTE: The ONLINE/OFFLINE button must be pressed for a minimum of 4 seconds for the

power off or power on to occur.

• Extractor clips—Control the locking system that secures the Routing Engine.

LEDs—"PTX5000 Routing Engine LEDs" on page 123

NOTE: For specific information about Routing Engine components (for example, the amount of

DRAM), issue the show chassis routing-engine command.

RE-PTX-X8-128G Routing Engine Components

The RE-PTX-X8-128G Routing Engine has increased memory and storage to support virtualization. The

Routing Engine is equipped with an 8 Core 2.3 GHz processor, 128GB Memory, and two 200GB SSDs. It

also supports Secure Boot for enhanced boot security.

Figure 61: RE-PTX-X8-128G Routing Engine Components

Extractor clips

LEDs—DISK1, DISK2, and ONLINE

ONLINE/OFFLINE button

Each Routing Engine (shown in

• CPU—Runs Junos OS to maintain the routing tables and routing protocols. The CPU is an eight-core

CPU with core frequency of 2.3 GHz.

• DRAM—Provides storage for the routing and forwarding tables and for other Routing Engine

• EEPROM—Stores the serial number of the Routing Engine.

The faceplate of the Routing Engine contains the following:

Figure 61 on page

121) consists of the following components:

describes the functions of these LEDs.

RESET button

USB0 and USB1 ports

SSD card slot cover

Table of Contents