c. Push the ejector handle toward the PSM, and tighten the captive screw on the ejector handle to
secure it to the PSM.
d. Repeat these steps for all the other PSMs in the PDU.
7.
Using a number 2 Phillips (+) screwdriver, loosen the two screws from the metal door of the metal
AC wiring compartment located in the middle of the PDU for 20-A inputs and lower part of the
PDU for the 30-A inputs.
8.
Using a number 2 Phillips (+) screwdriver, loosen the screw on the 20-A input terminal and plug in
the connector.(see
Figure 216 on page
410). Tighten the screw after plugging in the connector.
408