Installing An Acx4000 Console Or Auxiliary Cable - Juniper ACX4000 Hardware Manual

2. Press the tab on the connector, and pull the connector straight out of the CONSOLE/AUX port.
Figure 6 shows the connector.
3. Disconnect the cable from the console or auxiliary device.
Figure 30: Ethernet Cable Connectors
SEE ALSO
Console or Auxiliary Port Connector Pinout on ACX Series Routers | 90
Replacing an ACX4000 Console or Auxiliary Cable | 132

Installing an ACX4000 Console or Auxiliary Cable

The CONSOLE/AUX port on the front panel of the router accepts an RS-232 (EIA-232) serial cable with
RJ-45 connectors.
To connect a cable between the router and the console or auxiliary device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Connect one end of the replacement cable into the CONSOLE/AUX port.
3. Plug the other end of the cable into the device's serial port.
SEE ALSO
Console or Auxiliary Port Connector Pinout on ACX Series Routers | 90
Replacing an ACX4000 Console or Auxiliary Cable | 132
RELATED DOCUMENTATION
Console or Auxiliary Port Connector Pinout on ACX Series Routers | 90
133