Juniper PTX5000 Hardware Manual page 419

9. Using a number 2 Phillips (+) screwdriver, tighten the four captive screws on the metal retaining
bracket to secure the AC power cord to the PDU. See
Figure 209: Connecting the Metal Retaining Bracket and AC Power Cord to the High Capacity
Wye PDU
10. Connect the wires to the AC terminal block on the High Capacity Wye AC PDU
page 402). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen the input terminal screws and the
grounding point screw, and insert each wire into the grounding point or input terminal, and tighten
the screw.
a. Insert the wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.
d. Insert the wire labeled L3 into the L3 input terminal.
Figure 209 on page 401.
(Figure 210 on
401