Replacing A Cfp2 Transceiver - Juniper PTX5000 Hardware Manual

CAUTION: Do not let fiber-optic cable hang free from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause problems that
are difficult to diagnose.
7. Verify that the status LEDs on the PIC faceplate indicate that the CFP is functioning correctly. For
more information about the PIC LEDs, see the
verify PIC functioning by issuing the show chassis fpc pic-status command.

Replacing a CFP2 Transceiver

IN THIS SECTION
Removing a CFP2 Transceiver | 535
Installing a CFP2 Transceiver | 536
PTX Series Interface Module Reference. You can also
534