Installing A Ptx5000 Vertical Air Filter - Juniper PTX5000 Hardware Manual

Figure 159: Removing a Vertical Air Filter

Installing a PTX5000 Vertical Air Filter

To install the vertical air filter:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Locate markings on the side of the frame indicating airflow direction.
3. Position the air filter over the air filter tray. Note the correct orientation for airflow direction. The
airflow direction is front to rear, through the perforated faceplate, and up through the filter.
4. Engage the edge nearest the perforated faceplate under the front flange, and slide the filter further
toward the faceplate (see
Engage the opposite filter edge under the retainer bracket at the rear of the air filter tray and snap
the air filter into place.
5. Reinstall the vertical air filter tray into chassis
Figure 160 on page 338).
(Figure 161 on page 339).
337