Committing The Configuration - Juniper PTX5000 Hardware Manual

3. Configure the domain name of the PTX5000.
[edit]
root@# set system domain-name
4. Configure the IP address and prefix length for the PTX5000 router's management Ethernet interface.
[edit]
root@# set interfaces em0 unit 0 family inet address
5. Configure the IP address of a backup router. The backup router allows the PTX5000 to install a route
to the management network while the Routing Engine is booting and before the routing protocol
process (rpd) is up and running. The backup router must be directly connected—that is, on the same
subnet—through the management Ethernet interface.
[edit]
root@# set system backup-router
6. (Optional) Configure the static routes to remote subnets with access to the management port. Access
to the management port is limited to the local subnet. To access the management port from a remote
subnet, you must add a static route to that subnet within the routing table.
[edit]
root@# set routing-options static route
readvertise
7. Configure the Telnet service at the [edit system services] hierarchy level.
[edit]
root@# set system services telnet

Committing the Configuration

domain-name
address/prefix-length
address
remote-subnet next-hop destination-IP retain no-
306