NOTE: It is not necessary to remove the power cables from the input power trays when you
are replacing the PDU.
10. Loosen the four captive screws attaching the PDU handle to the PDU and chassis.
11. Grasp the handle on the PDU faceplate and pull firmly down toward you. Slide the PDU halfway
out of the chassis (see
Figure 223: Removing a 60-A DC PDU
12. Place one hand underneath the PDU to support it and slide it partly out of the chassis until you can
reach the two handles located on each side of the PDU.
13. Use the two handles on each side of the PDU to support it and slide the PDU completely out of the
chassis.
Figure
2).
422