Juniper PTX5000 Hardware Manual page 311

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

NOTE: After powering off a PDU, you must wait at least 60 seconds before powering it on again.

Verify that the PDUs and PSMs are fully inserted in the chassis and that the captive screws on the

faceplates are tightened.

Verify that an external management device is connected to one of the Routing Engine ports on the

Control Board (AUXILIARY or CONSOLE).

NOTE: The management Ethernet port labeled HOST/ETHERNET on the Control Board is

not available until after the initial software configuration. You can monitor the startup

process during the initial installation using devices connected to the AUXILIARY or

CONSOLE ports.

Turn on power to the external management device.

Switch on the customer-site circuit breakers to provide voltage to the AC power cords.

Verify that the PDUs are receiving power. Verify that the green PDU OK LED is lit steadily green.

Switch on one of the PDUs to by turning its power switch to the on (|) position.

NOTE: After a PDU is powered on, it can take up to 60 seconds for status indicators—such

as the LEDs on the PDU and PSMs, the command output displays, and messages on the

LCD display on the craft interface—to indicate that the PDU and PSMs are functioning

normally. Ignore error indicators that appear during the first 60 seconds.

Verify that the PDU OK LED on the PDU faceplate is lit steadily, which indicates that the PDU is

correctly installed and is functioning properly.

NOTE: If the PDU OK LED does not light steadily, repeat the installation and cabling

Chapters

Table of Contents