Juniper PTX5000 Hardware Manual page 400

382
screwdriver, use the four screws on the metal retaining bracket to secure the AC power cord to the
PDU (see Figure 192 on page 382).
Figure 192: Connecting the Metal Retaining Bracket and AC Power Cord to the Three-Phase Wye
PDU
6. Connect the wires to the AC terminal block on the three-wye AC PDU (Figure 193 on page 383).
Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen each of the input terminals or grounding point
screws, insert each wire into the grounding point or input terminal, and tighten the screw.
a. Insert the wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.
d. Insert the wire labeled L3 into the L3 input terminal.