Installing The Routing Engine Re-Ptx-X8-64G - Juniper PTX5000 Hardware Manual

Installing the Routing Engine RE-PTX-X8-64G

Figure 254: Installing the RE-PTX-X8-64G Routing Engine
NOTE: While installing, ensure that you install the Routing Engine RE-PTX-X8-64G into the
Control Board CB2-PTX only.
To install a Routing Engine (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Ensure that the ejector handles are not in the locked position. If necessary, press the red tabs and flip
the ejector handles outward.
3. Place one hand underneath the Routing Engine to support it. With the other hand, grasp one of the
ejector handles on the faceplate.
4. Carefully align the sides of the Routing Engine with the guides inside the opening on the Control
Board.
5. Slide the Routing Engine into the chassis until you feel resistance, and then press the Routing
Engine's faceplate until it engages the connectors.
6. Press both the ejector handles inward to seat the Routing Engine.
7. Reconnect the cables and verify that the Routing Engine is installed correctly and functioning
properly:
Figure 254 on page 478):
478