Juniper PTX5000 Hardware Manual page 641

PSM 0
Input 1
PSM 1
Input 1
PSM 2
Input 1
PSM 3
Input 1
• Offlined due to config—Check if the FPC is configuration to be off. See
Offlinepower
.
• Unresponsive—There might be a hardware failure on the FPC. Reseat the FPC and reboot.
In Table 98 on page 623, the text in the LCD Message column appears in the display of the craft
interface. The text in the CLI Message column appears in the output of the show chassis alarms command.
Table 98: Troubleshooting FPC Alarms
Alarm LCD Message
Type
fpc-number
Red FPC
unreachable PFEs
detected
FPC fpc-number
unreachable PFEs
offlined
Yellow Power Budget:
Minor alarm
54 348
54 630
0 0
54 2065
CLI Message Alarm Condition
fpc-number
FPC FPC is not able to forward
traffic because of a fabric
unreachable PFEs
failure.
detected
FPC fpc-number
FPC is not able to forward
traffic due to a fabric failure.
unreachable PFEs
offlined
Power Budget: No Redundant power is not
available for one or more
redundant power
FPCs. If the nonredundant
PSM providing power to an
FPC fails, the FPC will lose
service.
Configuring a FPC to Stay
Recovery
Contact JTAC. JTAC needs to
analyze the logs to see the
reason for the fabric failure.
Contact JTAC. JTAC needs to
analyze the logs to see the
reason for the fabric failure.
•
If any PSM is missing, add
the PSM.
•
If any PSM fails, replace the
PSM.
623