Copying The Junos Os To The Solid-State Disk In A Ptx5000 Routing Engine - Juniper PTX5000 Hardware Manual

2. Reinstall the Routing Engine cover and tighten the screws on the corners of the cover to secure it to
the Routing Engine (using a number 2 Phillips (+) screwdriver).
3. From the primary Routing Engine, issue the request system power-on other-routing-engine command to
power on the Routing Engine.
Figure 252: Installing an SSD Drive in a RE-DUO-C2600-16G

Copying the Junos OS to the Solid-State Disk in a PTX5000 Routing Engine

After installing a solid-state disk (SSD) for the first time, you must copy the software from the Routing
Engine's CompactFlash card to the SSD drive.
To copy software to the SSD drive:
1. On the console or other management device connected to the Routing Engine, enter CLI operational
mode.
2. Partition the SSD drive. Issue the request system partition hard-disk command.
3. Wait until a message appears on the console confirming that the partition procedure is complete.
4. Reboot the router's software. Issue the request system reboot command.
5. Back up the currently running and active file system partitions on the router to standby partitions
that are not running. Issue the request system snapshot command.issue the request system snapshot
command.
6. Wait until a message appears on the console confirming that the snapshot procedure is complete.
7. Reboot the router's software again. Issue the request system reboot command.
8. Verify that the SSD drive is listed as the secondary boot device. The output lists the devices
mounted. The SSD drive is located at ad1. issue the show system boot-messages command.
474