6.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
7.
Remove the cover from the Routing Engine slots by loosening the captive screws on the corners of
the cover (using a number 2 Phillips (+) screwdriver).
CAUTION: Do not remove the cover if any of the LEDs are lit.
8.
Press the eject button on the right side of the CompactFlash card slot to release the CompactFlash
card.
9.
The CompactFlash card pops partially out of the slot. Grasp the card and pull it completely out of
the slot.
10. Place the CompactFlash card on the antistatic mat.
Figure 249: Removing a Routing Engine CompactFlash Card
Installing a CompactFlash Card in a PTX5000 Routing Engine
To install a CompactFlash card (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the cover from the Routing Engine slots by loosening the captive screws on the corners of
the cover (using a number 2 Phillips (+) screwdriver).
3. Insert the CompactFlash card into the CompactFlash card slot on the Routing Engine, with the logo
facing up.
CAUTION: Be sure to insert the CompactFlash card with the label facing up. Inserting
the CompactFlash card incorrectly might damage the Routing Engine.
4. Press the card firmly all the way into the slot.
Figure 250 on page
471):
470