Powering On The Ptx5000 - Juniper PTX5000 Hardware Manual

To install the new SIBs:
Figure 292: Installing a SIB
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Press and hold the ONLINE/OFFLINE button on the SIB faceplate. The green OK LED on the
faceplate turns off. Hold the button down until the LED completely turns off.
3. Place one hand underneath the SIB to support it. With the other hand, hold one of the ejector
handles on the SIB faceplate.
4. Carefully align the sides of the SIB with the guides inside the chassis.
5. Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
6. Twist the ejector handles clockwise until they stop.
7. Install all the SIBs one by one.

Powering On the PTX5000

1. Verify that the PDUs and power supply modules (PSMs) are fully inserted in the chassis and that
the captive screws on the faceplates are tightened by using a number 2 Phillips (+) screwdriver.
2. Power on the router. Depending on the power supplies used on the router, see
DC Powered PTX5000 with 120-A DC PDUs and 120-A DC PSMs" on page 296
"Powering On the
or "Powering On
562