Juniper PTX5000 Hardware Manual page 425

2. Move the power switch located on the faceplate of the PDU to the standby
(
) position.
3. Grasping both the front and top installation handles, insert the replacement PDU into the PDU slot.
See Figure 214 on page
Figure 214: Installing a Single-Phase AC PDU
4. Using both hands, slide the PDU into the chassis until you feel resistance.
5. Push the front installation handle up toward the PDU. Using a number 2 Phillips (+) screwdriver,
tighten the captive screws on the handle.
6. Reinstall the PSMs into the PDU.
a. Loosen the captive screws on the door covering the PSMs and open the door.
b. Place one hand underneath the PSM to support it and slide it into the PSM slot.
407.
407