Replacing An Ssd Drive On A Re-Duo-C2600-16G; Removing An Ssd Drive From A Re-Duo-C2600-16G - Juniper PTX5000 Hardware Manual

Replacing an SSD Drive on a RE-DUO-C2600-16G

IN THIS SECTION

Removing an SSD Drive From a RE-DUO-C2600-16G | 472

Installing an SSD Drive in a RE-DUO-C2600-16G | 473
Copying the Junos OS to the Solid-State Disk in a PTX5000 Routing Engine | 474
Removing an SSD Drive From a RE-DUO-C2600-16G
The solid-state disk (SSD) drive is located in the slot labeled Disk1 on the Routing Engine faceplate.
NOTE: The Disk 2 slot is not currently supported.
To remove an SSD drive from a Routing Engine (see
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Determine whether the host subsystem is functioning as the primary or as the backup, using one of
these methods:
• Check the HOST 0 and HOST 1 LEDs on the craft interface. If the green MASTER LED is lit, the
corresponding host subsystem is functioning as the primary.
• Check the MASTER LED on the Control Board. If the blue MASTER LED is lit, the host
subsystem is functioning as the primary.
• Issue the following CLI command. The primary Routing Engine is designated Master in the Current
state field:
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state
...
If the host subsystem is functioning as the primary, switch it to backup using the request chassis
3.
routing-engine master switch command.
Figure 5):
Master
472