Juniper PTX5000 Hardware Manual page 476

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

• PSM sleeve and bracket—eight for each chassis (provided)

NOTE: Each PSM sleeve can house two PSMs.

• PSM slot label—two for each chassis (provided)

Installing the Metal Sleeves for High Capacity AC or DC PSMs

To install the High Capacity AC and DC PSM sleeve assembly:

1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on

the chassis.

2. Remove the existing PSMs from the chassis. See

"Replacing a PTX5000 Normal-Capacity AC PSM" on page 384

3. Take out the PSM sleeve assembly from the upgrade kit and remove the bracket by using a number 1

Phillips (+) screwdriver.

4. Insert the sleeve into one of the empty PSM slots and push the sleeve in until it is flush against the

side of the chassis (see

Figure 244: Inserting High Capacity PSM Sleeve

Figure 244 on page

"Replacing a PTX5000 60-A or 120-A DC PSM" on

for details.

Chapters

Table of Contents