Juniper PTX5000 Hardware Manual page 387

wiring compartment, remove the metal retaining bracket and AC power cord from the PDU. See
Figure 17.
Figure 182: Removing the Metal Retaining Bracket and AC Power Cord
9. Loosen the four captive screws attaching the front PDU handle to the PDU and chassis.
10. Grasp the front installation handle on the PDU faceplate and pull the handle firmly down toward
you. Slide the PDU halfway out of the chassis until you can reach the top installation handle. (See
Figure 19.)
11. Use the top and front installation handle to slide the PDU completely out of the chassis.
CAUTION: Each PDU weighs approximately 51.2 lb (23.2 kg). Be prepared to
support the full weight of the PDU as you remove it from the PTX5000.
WARNING: Do not touch the power connectors on the rear of the PDU. They can
contain dangerous voltages.
369