Connector Pinouts For The Ptx5000 Management Host/Ethernet Port - Juniper PTX5000 Hardware Manual

RJ-45 Connector Pinouts for the PTX5000 Management HOST/
ETHERNET Port
The management Ethernet port on the Control Board labeled HOST/ETHERNET is an autosensing
10/100-Mbps/1-Gbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the
Routing Engine to a management LAN (or other device that supports out-of-band management).
74 on page 195 describes the RJ-45 connector pinouts.
Table 74: RJ-45 Connector Pinouts
Pin Signal
1 TX+
2 TX –
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
SEE ALSO
PTX5000 Control Board Description | 131
Connecting the PTX5000 to a Management Ethernet Device | 276
195
Table