MX104 3D Universal Edge Router Hardware Guide
Installing an MX104 Console or Auxiliary Cable
Related
Documentation
Replacing an MX104 Management Ethernet Cable
Removing an MX104 Management Ethernet Cable
138
The
CONSOLE
port on the front panel of the router accepts an RS-232 (EIA-232) serial
cable with RJ-45 connectors.
NOTE:
The
AUX
To connect a cable between the router and the console or auxiliary device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Connect one end of the replacement cable into the
2.
Plug the other end of the cable into the device's serial port.
3.
MX104 Routing Engine Auxiliary and Console Ports Specifications on page 85
Removing an MX104 Management Ethernet Cable on page 138
1.
Installing an MX104 Management Ethernet Cable on page 139
2.
To remove a serial cable connected to a management device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
port.
Figure 36 on page 138
Disconnect the cable from the network device.
3.
Figure 36: Ethernet Cable Connectors
port is not supported.
shows the connector.
CONSOLE/AUX
port.
ETHERNET
Copyright © 2017, Juniper Networks, Inc.