5. Place one hand underneath the PSM to support it and slide it completely out of the chassis.
Figure 239: Removing a PSM
Installing a PTX5000 60-A or 120-A DC PSM
Each DC PSM weighs approximately 10.6 lb (4.8 kg). To install a 60-A or 120-A DC PSM:
1. Using both hands, slide the PSM into the chassis until you feel resistance .
2. Actuate the ejector handle to insert the PSM into the chassis.
3. Tighten the captive screw on the PSM.
4. Verify that the INPUT OK LED on the PSM faceplate is lit steadily, indicating that the PSM is
receiving power.
5. Verify that the OUTPUT OK LED on the PSM faceplate is lit steadily.
Replacing a PTX5000 High Capacity DC PDU
IN THIS SECTION
Removing a PTX5000 High Capacity DC PDU | 443
Installing a PTX5000 High Capacity DC PDU | 445
442