Installing an M320 Console or Auxiliary Cable
Copyright © 2015, Juniper Networks, Inc.
Figure 70: Routing Engine Console or Auxiliary Cable
HOST
0
ETHERNET
ACT 0
YEL = 10M
GRN = 100M
CONSOLE
AUXILIARY
HOST
1
ETHERNET
ACT 1
YEL = 10M
GRN = 100M
CONSOLE
AUXILIARY
RED ALARM
NC
C
NO
NC
C
NO
YELLOW
ALARM
To install a console or auxiliary cable:
Turn off the power to the console or auxiliary device.
1.
Connect one end (shown in
2.
the appropriate CONSOLE or AUX port. The external device ports on the CIP. The
ports labeled
connect to the Routing Engine in the upper Routing Engine slot
HOST 0
(
), and the ports labeled
RE0
Engine slot (
RE1
).
Chapter 24: Replacing Chassis Components
Figure 71 on page
196) of the replacement serial cable into
connect to the Routing Engine in the lower Routing
HOST 1
195