Replacing A Ptx5000 Normal-Capacity Ac Psm; Removing A Ptx5000 Ac Psm - Juniper PTX5000 Hardware Manual

17. Verify that the PDU OK LED on the PDU faceplate is lit steadily, indicating that the PDU is
functioning normally.

Replacing a PTX5000 Normal-Capacity AC PSM

IN THIS SECTION

Removing a PTX5000 AC PSM | 384

Installing a PTX5000 AC PSM | 385
Removing a PTX5000 AC PSM
To remove an AC PSM:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the captive screws on the door covering the PSM and open the door.
3. Loosen the captive screw on the PSM ejector handle.
4. Grasp the ejector handle and pull to eject the PSM. Slide it halfway out of the chassis (see
CAUTION: Each AC PSM weighs approximately 10.5 lb (4.8 kg). Be prepared to
support the full weight of the PSM as you remove it from the PTX5000.
384
Figure 29).