3. Verify that the Routing Engine LEDs are off. Loosen the captive screws on the top and bottom of the
Routing Engine.
4. Grasp the Routing Engine by the ejector handles, and slide it about halfway out of the chassis.
5. Place one hand underneath the Routing Engine to support it, and slide it completely out of the
chassis. Place the Routing Engine on an antistatic mat.
Removing the Control Board During Upgrade
Figure 266: Removing a Control Board
To remove a Control Board (see
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
3. Label and disconnect the cables.
4. Rotate the ejector handles counterclockwise on both sides of the Control Board faceplate.
5. Grasp the ejector handles and slide the Control Board about halfway out of the chassis.
6. Place one hand underneath the Control Board to support it and slide it completely out of the chassis.
Place it on the antistatic mat.
Figure 266 on page
496):
496