Figure 124: Routing Power Cables Through the Comb Assembly
Widening the Cable Management Comb Assembly Extension
NOTE: The cable manager comb assembly extension is fixed at the minimum (default) position
when shipped. You can widen the comb assembly, if the rear edge of the PTX5000 chassis
extends out from the rack post and you do not have enough space to route the cables with the
default comb assembly extension width.
To widen the comb assembly extension:
1. Unfasten the screws that join the two plates of the cable manager extension panel assembly. Realign
the plates along the next set of holes so that the extension is at the maximum length. See
2. Reassemble the extension plates by fastening the six screws by using a number 2 Phillips (+)
screwdriver.
260
Figure
1.