SEE ALSO
Console or Auxiliary Port Connector Pinout on ACX Series Routers | 89
Installing an ACX1000 or ACX1100 Console or Auxiliary Cable
The CONSOLE/AUX port on the front panel of the router accepts an RS-232 (EIA-232) serial cable with
RJ-45 connectors.
To connect a cable between the router and the console or auxiliary device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Connect one end of the replacement cable into the CONSOLE/AUX port.
3. Plug the other end of the cable into the device's serial port.
SEE ALSO
Console or Auxiliary Port Connector Pinout on ACX Series Routers | 89
Replacing an ACX1000 or ACX1100 Management Ethernet Cable
IN THIS SECTION
Removing an ACX1000 or ACX1100 Management Ethernet Cable | 123
Installing an ACX1000 and ACX1100 Management Ethernet Cable | 124
Removing an ACX1000 or ACX1100 Management Ethernet Cable
To remove a serial cable connected to a management device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Press the tab on the connector, and pull the connector straight out of the MGMT port.
shows the connector.
123
Figure 2