Juniper PTX5000 Hardware Manual page 418

6. Using a number 2 Phillips (+) screwdriver, loosen the four captive screws on the metal retaining
bracket located on the lower right of the newly installed PDU. Remove the metal retaining bracket
from the PDU. See
Figure 208: Removing the Metal Retaining Bracket from the High Capacity Wye PDU
7. Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal AC wiring
compartment of the replacement PDU. Open the metal door of the metal AC wiring compartment.
8. Gently push the wires of the AC power cord into the area for the metal retaining bracket, and pull
the wires to the left toward the metal AC wiring compartment.
Figure 208 on page 400.
400