Installing An Ssd Drive In A Re-Duo-C2600-16G - Juniper PTX5000 Hardware Manual

4. From the primary Routing Engine, issue the request system power-off other-routing-engine to power
down the backup Routing Engine.
5. Verify that the Online, Disk1 , and CF LEDs on the backup Routing Engine faceplate are off.
6. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
7. Remove the cover from the Routing Engine slots by loosening the captive screws on the corners of
the cover (using a number 2 Phillips (+) screwdriver).
CAUTION: Do not remove the cover if any of the LEDs on the Routing Engine
faceplate are lit.
8. Press the eject button on the right side of the Disk1 slot to release the SSD drive.
9. The SSD drive pops partially out of the slot. Grasp the SSD drive and carefully slide it completely
out of the slot.
10. Place the SSD drive on the antistatic mat.
Figure 251: Removing an SSD Drive From a RE-DUO-C2600-16G

Installing an SSD Drive in a RE-DUO-C2600-16G

To install an SSD drive in a Routing Engine (see
1. Insert the SSD drive into the Disk1 slot on the Routing Engine, with the logo facing down.
CAUTION: Be sure to insert the SSD drive with the label facing down. Inserting the
SSD drive incorrectly might damage the Routing Engine.
Slide the SSD drive into the slot until you feel resistance, carefully ensuring that it is correctly aligned.
Figure 252 on page 474):
473