Replacing a PTX5000 Craft Interface
IN THIS SECTION
Removing a PTX5000 Craft Interface | 314
Installing a PTX5000 Craft Interface | 315
Removing a PTX5000 Craft Interface
The craft interface is located on the upper front of the PTX5000 chassis. The craft interface weighs
approximately 2.6 lb (1.2 kg). The craft interface is hot-insertable and hot-removable.
To remove the craft interface (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the screws at the four corners of the craft interface, using a number 2 Phillips (+) screwdriver.
3. Grasp the craft interface, and support it a few inches in front of the chassis.
4. Locate the ribbon cable behind the left side of the craft interface.
5. Squeeze the latches on either side of the ribbon cable connector where it attaches to the rear of the
craft interface, and gently disconnect the cable.
Figure 144: Removing the Craft Interface
Figure
1):
314