Installing A Management Console Or Auxiliary Port Cable; Replacing A Ptx5000 Management Ethernet Cable; Figure 260: Installing The Console Or Auxiliary Port Cable - Juniper PTX5000 Hardware Manual

Installing a Management Console or Auxiliary Port Cable

Related
Documentation

Replacing a PTX5000 Management Ethernet Cable

Copyright © 2017, Juniper Networks, Inc.

Figure 260: Installing the Console or Auxiliary Port Cable

1— Console port
To install a management console or auxiliary device cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If necessary, turn off the power to the console or auxiliary device.
2.
Plug one end of a copper cable with RJ-45 connectors into the
3.
port on the Control Board in slot
into the Control Board in slot
Attach the other end of the cable to the console or auxiliary device.
4.
Plug one end of another copper cable with RJ-45 connectors into the
5.
port on
AUXILIARY CB1
control in slot .
CB1
Attach the other end of the cable to the console or auxiliary device.
6.
PTX5000 Control Board Description on page 83
Connecting the PTX5000 Packet Transport Router to a Management Console or
Auxiliary Device on page 188
Prevention of Electrostatic Discharge Damage on page 611
Removing a PTX5000 Management Ethernet Cable on page 408
1.
Installing a PTX5000 Management Ethernet Cable on page 408
2.
Chapter 29: Removing and Installing Host Subsystem Components
1 2
2— Auxiliary port
. This port connects to the Routing Engine installed
CB0
CB0 .
. This port connects to the Routing Engine installed into the
or
CONSOLE AUXILIARY
CONSOLE or
407