Juniper PTX5000 Hardware Manual page 382

6. Using a number 2 Phillips (+) screwdriver, use the four screws on the metal retaining bracket to
secure the AC power cord to the PDU.
Figure 178: Connecting the Metal Retaining Bracket and AC Power Cord to the Three-Phase Delta
PDU
7. Connect the wires to the AC terminal block on the three-phase delta AC PDU
365). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen the input terminal or grounding point
screw, insert each wire into the grounding point or input terminal, and tighten the screw.
a. Insert the wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.
(Figure 179 on page
364