ACX1000 and ACX1100 Universal Access Router Hardware Guide
Installing an ACX1000 or ACX1100 Console or Auxiliary Cable
Related
Documentation
Replacing an ACX1000 or ACX1100 Management Ethernet Cable
Removing an ACX1000 or ACX1100 Management Ethernet Cable
Installing an ACX1000 and ACX1100 Management Ethernet Cable
Related
Documentation
68
The
CONSOLE/AUX
port on the front panel of the router accepts an RS-232 (EIA-232)
serial cable with RJ-45 connectors.
To connect a cable between the router and the console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Connect one end of the replacement cable into the
2.
Plug the other end of the cable into the device's serial port.
3.
Console/Auxiliary Port Connector Pinout on ACX Series Routers on page 134
1.
Removing an ACX1000 or ACX1100 Management Ethernet Cable on page 68
Installing an ACX1000 and ACX1100 Management Ethernet Cable on page 68
2.
To remove a serial cable connected to a management device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
Figure 27 on page 68
shows the connector.
Disconnect the cable from the network device.
3.
Figure 27: Ethernet Cable Connectors
To install a serial cable connected to a management device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of the replacement cable into the appropriate
2.
Plug the other end of the cable into the network device.
3.
Management Port Connector Pinout Information for ACX Series Routers on page 133
CONSOLE/AUX
port.
MGMT
MGMT
port.
Copyright © 2013, Juniper Networks, Inc.
port.