Tools And Parts Required To Remove Components From A Ptx5000; Packing The Ptx5000 For Shipment - Juniper PTX5000 Hardware Manual

Tools and Parts Required to Remove Components from a PTX5000

To remove components from the PTX5000 or the PTX5000 from a rack, you need the following tools
and parts:
• 2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
• 7/16-in. (11-mm) nut driver
• Blank panels to cover empty slots
• Electrostatic bag or antistatic mat, for each component
• Electrostatic discharge (ESD) grounding wrist strap
• Flat-blade (–) screwdriver
• Mechanical lift (for the chassis)
• Phillips (+) screwdrivers, numbers 1 and 2
• Rubber safety cap for fiber-optic interfaces and cable
• Wire cutters

Packing the PTX5000 for Shipment

To pack the PTX5000 for shipment:
1. Retrieve the shipping crate and packing materials in which the PTX5000 was originally shipped. If
you do not have these materials, contact your Juniper Networks representative about approved
packaging materials.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
3. On the console or other management device connected to the primary Routing Engine, enter CLI
operational mode. To power off the PTX5000, see
4. Disconnect power from the PTX5000. For instructions, see the procedure to disconnect power
in"Replacing a PTX5000 120-A DC PDU" on page
5. Remove the cables that connect to all external devices..
6. Remove all Field Replaceable Units (FRUs) from the PTX5000.
7. Remove the PTX5000 from the rack. Place the mechanical lift platform under the router, unscrew
and remove the mounting screws from the rack, and move the router to the shipping crate.
"Powering Off the PTX5000" on page
431.
658
299.