Installing an SSD Drive in a RE-DUO-C2600-16G
Copyright © 2017, Juniper Networks, Inc.
Remove the cover from the Routing Engine slots by loosening the captive screws on
7.
the corners of the cover (using a number 2 Phillips (+) screwdriver).
CAUTION:
Do not remove the cover if any of the LEDs on the Routing
Engine faceplate are lit.
Press the eject button on the right side of the
8.
The SSD drive pops partially out of the slot. Grasp the SSD drive and carefully slide it
9.
completely out of the slot.
Place the SSD drive on the antistatic mat.
10.
Figure 251: Removing an SSD Drive From a RE-DUO-C2600-16G
To install an SSD drive in a Routing Engine (see
Insert the SSD drive into the
1.
down.
CAUTION:
Be sure to insert the SSD drive with the label facing down.
Inserting the SSD drive incorrectly might damage the Routing Engine.
Slide the SSD drive into the slot until you feel resistance, carefully ensuring that it is
correctly aligned.
Reinstall the Routing Engine cover and tighten the screws on the corners of the cover
2.
to secure it to the Routing Engine (using a number 2 Phillips (+) screwdriver).
From the master Routing Engine, issue the
3.
other-routing-engine
command to power on the Routing Engine.
Chapter 29: Removing and Installing Host Subsystem Components
slot to release the SSD drive.
Disk1
Figure 252 on page
slot on the Routing Engine, with the logo facing
Disk1
request system power-on
398):
397