Replacing An Ssd Drive On An Re-S-1800; Figure 117: Installing A Routing Engine - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing an SSD Drive on an RE-S-1800

278
Tighten the captive screws on the left and right of the Routing Engine.
7.
Connect the management device cables to the Routing Engine.
8.
The Routing Engine might require several minutes to boot.
After the Routing Engine boots, verify that it is installed correctly by checking the
, and LEDs on the craft interface. If the router is operational and the Routing
RE0 RE1
Engine is functioning properly, the green
lights steadily instead, remove and install the Routing Engine again. If the red
still lights steadily, the Routing Engine is not functioning properly. Contact your customer
support representative.
To check the status of the Routing Engine, use the CLI command:
user@host> show chassis routing-engine
Routing Engine status:
For more information about using the CLI, see the Junos OS documentation.

Figure 117: Installing a Routing Engine

MX240 Routing Engine Description on page 23
Effect of Taking the MX240 Host Subsystem Offline
Taking an MX240 Host Subsystem Offline
Replacing Connections to MX240 Routing Engine Interface Ports on page 285
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
Synchronizing Routing Engines
Each RE-S-1800 Routing Engine supports two solid-state drives (SSD) specified by
Juniper Networks. The RE-S-1800 ships with one SSD installed in the slot labeled
LED lights steadily. If the red
ONLINE
Slot 0: Current state
Copyright © 2017, Juniper Networks, Inc.
FAIL ,
LED
FAIL
FAIL LED
Master ...
SATA