Replacing An Ssd Drive On An Re-S-1800; Figure 132: Installing A Routing Engine - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing an SSD Drive on an RE-S-1800

336
Tighten the captive screws on the left and right of the Routing Engine.
7.
Connect the management device cables to the Routing Engine.
8.
The Routing Engine might require several minutes to boot.
After the Routing Engine boots, verify that it is installed correctly by checking the
, and LEDs on the craft interface. If the router is operational and the Routing
RE0 RE1
Engine is functioning properly, the green
lights steadily instead, remove and install the Routing Engine again. If the red
still lights steadily, the Routing Engine is not functioning properly. Contact your customer
support representative.
To check the status of the Routing Engine, use the CLI command:
user@host> show chassis routing-engine
Routing Engine status:
For more information about using the CLI, see the Junos OS documentation.

Figure 132: Installing a Routing Engine

Preventing Electrostatic Discharge Damage to an MX960 Router
Replacing Connections to MX960 Routing Engine Interface Ports on page 343
MX960 Routing Engine Description on page 29
Routing Engine Interface Cable and Wire Specifications for MX Series Routers on
page 142
Synchronizing Routing Engines
Each RE-S-1800 Routing Engine supports two solid-state drives (SSD) specified by
Juniper Networks. The RE-S-1800 ships with one SSD installed in the slot labeled
. The spare SSD is Juniper part number RE-SSD-32G-UPG.
SSD 1
shows the arrangement of storage drive slots on a RE-S-1800 Routing Engine.
LED lights steadily. If the red
ONLINE
Slot 0: Current state
Copyright © 2017, Juniper Networks, Inc.
FAIL ,
LED
FAIL
FAIL LED
Master ...
SATA
Figure 133 on page 337