Installing A Solid-State Disk From A T4000 Re-C1800 Routing Engine; Engine; Figure 117: Installing An Ssd - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide

Installing a Solid-State Disk From a T4000 RE-C1800 Routing Engine

Copying Junos OS to the Solid-State Disk in a T4000 RE-C1800 Routing Engine
292
To install an SSD in a Routing Engine (see
Insert the SSD into the
1.
CAUTION: Be sure to insert the SSD with the label facing down. Inserting
the SSD incorrectly might damage the Routing Engine.
Slide the SSD into the slot until you feel resistance, carefully ensuring that it is correctly
2.
aligned.
Reinstall the Routing Engine cover. Using a Phillips (+) screwdriver, number 2, tighten
3.
the screws on the corners of the cover to secure it to the Routing Engine .
From the master Routing Engine, power on the Routing Engine. Issue the
4.
system power-on other-routing-engine

Figure 117: Installing an SSD

After installing a solid-state disk (SSD) for the first time, you must copy the software
from the Routing Engine's CompactFlash card to the SSD.
To copy software to the SSD:
On the console or other management device connected to the Routing Engine, enter
1.
CLI operational mode.
Partition the SSD. Issue the
2.
Wait until a message appears on the console confirming that the partition procedure
3.
is complete.
Reboot the router's software. Issue the
4.
Figure 117 on page
slot on the Routing Engine, with the logo facing down.
DISK1
command.
request system partition hard-disk
request system reboot
292):
request
command.
command.
Copyright © 2018, Juniper Networks, Inc.