Replacing An Ssd Drive On A Re-Duo-C2600-16G; Removing An Ssd Drive From A Re-Duo-C2600-16G - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Replacing an SSD Drive on a RE-DUO-C2600-16G

Removing an SSD Drive From a RE-DUO-C2600-16G

396
Removing an SSD Drive From a RE-DUO-C2600-16G on page 396
1.
Installing an SSD Drive in a RE-DUO-C2600-16G on page 397
2.
3. Copying the Junos OS to the Solid-State Disk in a PTX5000 Routing Engine on page 398
The solid-state disk (SSD) drive is located in the slot labeled
faceplate.
NOTE: The
Disk 2
To remove an SSD drive from a Routing Engine (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Determine whether the host subsystem is functioning as the master or as the backup,
2.
using one of these methods:
Check the HOST 0 and
is lit, the corresponding host subsystem is functioning as the master.
Check the LED on the Control Board. If the blue
MASTER
subsystem is functioning as the master.
Issue the following CLI command. The master Routing Engine is designated
in the field:
Current state
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state
...
If the host subsystem is functioning as the master, switch it to backup using the
3.
chassis routing-engine master switch
From the master Routing Engine, issue the
4.
to power down the backup Routing Engine.
other-routing-engine
Verify that the ,
5. Online Disk1
off.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
6.
the strap to one of the ESD points on the chassis.
slot is not currently supported.
Figure 251 on page
HOST 1 LEDs on the craft interface. If the green
Master
command.
request system power-off
, and LEDs on the backup Routing Engine faceplate are
CF
on the Routing Engine
Disk1
397):
MASTER
LED is lit, the host
MASTER
Master
request
Copyright © 2017, Juniper Networks, Inc.
LED