Replacing An Mx2000 Cb-Re; Removing A Cb-Re From An Mx2000 Router - Juniper MX2010 Hardware Manual

Replacing an MX2000 CB-RE

IN THIS SECTION

Removing a CB-RE from an MX2000 Router | 547

Installing an MX2020 CB-RE | 549
Installing an MX2010 CB-RE | 552
Removing a CB-RE from an MX2000 Router
To remove a CB-RE:
NOTE: You can remove the CB-RE as a unit.
CAUTION:
handles properly to avoid damage to the equipment.
CAUTION:
there is only one host subsystem, taking the host subsystem offline shuts down the
router.
1. Take the host subsystem offline.
2. Place an electrostatic bag or antistatic mat on a flat, stable surface.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
4. Open the ejector handles outward simultaneously to unseat the CB-RE.
5. Grasp the ejector handles, and slide the CB-RE about halfway out of the chassis.
Before removing a CB-RE, ensure that you know how to operate the ejector
Before you replace a CB-RE, you must take the host subsystem offline. If
547