Installing A Ptx5000 Vertical Air Filter; Figure 152: Inserting A Vertical Air Filter - Juniper PTX5000 Hardware Manual

Installing a PTX5000 Vertical Air Filter

Copyright © 2017, Juniper Networks, Inc.
To install the vertical air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Locate markings on the side of the frame indicating airflow direction.
2.
Position the air filter over the air filter tray. Note the correct orientation for airflow
3.
direction. The airflow direction is front to rear, through the perforated faceplate, and
up through the filter.
Engage the edge nearest the perforated faceplate under the front flange, and slide
4.
the filter further toward the faceplate (see
Engage the opposite filter edge under the retainer bracket at the rear of the air filter
tray and snap the air filter into place.
Reinstall the vertical air filter tray into chassis
5.
Tighten the captive screws to secure the air filter tray.
6.

Figure 152: Inserting a Vertical Air Filter

Chapter 26: Removing and Installing Cooling System Components
Figure 152 on page
(Figure 153 on page
275).
276).
275