Installing The Mx960 Air Filter - Juniper MX960 Hardware Manual

Connecting the Alarm Relay Wires to the MX960 Craft Interface | 367
MX960 Craft Interface Overview | 17

Installing the MX960 Air Filter

To install the air filter (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Ensure that the air filter is right side up.
3. Place the air filter into the air filter tray.
4. Insert the air filter tray into the chassis by sliding it straight into the chassis until it stops.
5. Lower the cable manager back into position.
6. Rearrange the cables in the cable manager.
Figure 134: Installing the Air Filter
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX960 Router
Removing the Normal-Capacity MX960 Air Filter | 453
Maintaining the MX960 Air Filter | 592
Figure 134 on page 383):
383