Installing The Mx240 Air Filter; Figure 80: Removing The Air Filter - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also
222
CAUTION: Always keep the air filter in place while the router is operating,
except during replacement. Because the fans are very powerful, they could
pull small bits of wire or other materials into the router through the unfiltered
air intake. This could damage the router components.
To remove the air filter (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Loosen the captive screws on the air filter cover.
2.
Remove the air filter cover.
3.
Slide the air filter out of the chassis.
4.

Figure 80: Removing the Air Filter

Preventing Electrostatic Discharge Damage to an MX240 Router on page 380

Installing the MX240 Air Filter

To install the air filter (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Locate the up arrow and ensure that the air filter is right side up.
2.
Slide the air filter straight into the chassis until it stops.
3.
Figure 80 on page 222):
Figure 81 on page 223):
Copyright © 2019, Juniper Networks, Inc.