Installing The Mx2010 Air Filter - Juniper MX2010 Hardware Manual

Figure 153: Installing an Adapter Card
RELATED DOCUMENTATION
MX2000 Adapter Card (ADC) Description | 69
Maintaining the MX2010 Adapter Cards | 606
Removing an MX2010 Adapter Card | 530

Installing the MX2010 Air Filter

To install the lower air filter—MX2010-FLTR-KIT-S:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Ensure that the air filter is right side up.
3. Open the fan tray and air filter access door, located at the bottom of the chassis.
4. Grasp the handle on the air filter and insert into the chassis until it stops (see
5. Close the access door and tighten the two captive screws to secure.
6. Lower the cable manager back into position, and rearrange the cables in the cable manager.
Figure 154 on page 362).
361