Installing The Mx480 Air Filter; Maintaining The Mx480 Fan Tray - Juniper MX480 Hardware Manual

Installing the MX480 Air Filter

To install the air filter (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Locate the up arrow and ensure that the air filter is right side up.
3. Slide the air filter straight into the chassis until it stops.
4. Align the captive screws of the air filter cover with the mounting holes on the chassis.
5. Tighten the captive screws on the air filter cover.
Figure 94: Installing the Air Filter
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX480 Router | 477
MX480 Cooling System Description | 43
Troubleshooting the MX480 Cooling System | 438

Maintaining the MX480 Fan Tray

Purpose
Figure 94 on page 291):
291