MX5, MX10, MX40, and MX80 Universal Routing Platforms Hardware Guide
See Also
100
Figure 39: Removing the Air Filter
Preventing Electrostatic Discharge Damage to an MX5, MX10, MX40, and MX80 Router
on page 146
Installing an MX5, MX10, MX40, and MX80 Air Filter
The air filter installs on the right side of the fan tray. To install the air filter (see
Figure 40 on page
101):
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Locate the
2.
THIS SIDE MUST FACE OUT
up.
Insert the air filter into the groove located toward the front of the fan tray.
3.
Press the tab on the rear of the fan tray to allow the air filter to slide into place.
4.
Release the tab to secure the air filter.
5.
Air filter
label, and ensure that the air filter is right side
Copyright © 2019, Juniper Networks, Inc.
Release
latch