Display Function Parameters; Monitor Display (Pr. 52 , Pr. 54 ) - Mitsubishi Electric FR-S500E Instruction Manual

Display function parameters

2.6 Display function parameters

2.6.1 Monitor display (Pr. 52
You can choose the display of the operation panel "monitor/frequency setting
screen".
Parameter Name
Operation panel
52 display data
selection
AM terminal function
54
selection
POINT
You can also use the
(basic) for the operation procedure.)
The analog current output terminal AM is available for signal output. (Make
selection using the Pr. 54 "AM terminal function selection" value.)
<Setting>
Signal Type
Output frequency
Output current
When "100" is set in Pr. 52, the monitored values during stop and during operation
differ as indicated below.
Output frequency
REMARKS
During an error, its definition appears.
During reset, the values displayed are the same as during a stop.
For selection of the parameter unit (FR-PU04) monitor display, refer to the communication
parameter n16 "PU main display screen data selection". (Page 150)
CAUTION
The unit displayed on the operation panel is only A and other units are not
displayed.
♦
Related parameters
Speed display ⇒ Pr. 37 "speed display" (refer to page 79)
Adjustment of level meter full-scale value ⇒ Calibration parameter C1 "AM terminal calibration"
Monitoring reference ⇒ Pr. 55 "frequency monitoring reference", Pr. 56 "current monitoring
Factory
Setting
0
0
to change the display. (Refer to the instruction manual
SET
Parameter Setting
Pr. 52
Unit
Operation panel
LED
Hz 0/100
A 1
0
During running/stop
Output frequency
♦
reference" (refer to page 90)
, Pr. 54
Setting
Range
0, 1, 100
Setting is enabled when Pr. 30 = "1"
0, 1
Pr. 54
AM terminal
0
1
Pr. 52
During stop
Set frequency
(refer to page 124)
88
)
Remarks
Full-Scale Value of AM
Level Meter
Pr. 55 "frequency monitoring
reference"
Pr. 56 "current monitoring
reference"
100
During running
Output frequency