Table of Contents
Advertisement
Production
6.3.2.3 Reorder with Preview
The reorder list must be entered, preview activated (see
Editing the Reorder List
The film strip is pulled in and scanned, the screen Reorder with preview opens.
The screen shows the preview images (maximum four images at the same time). The
display already considers the corrections of the selected configuration. Information about
the current configuration is shown below the row of preview frames.
A frame that is to be printed with different configurations is shown once per configuration.
The preview frames move automatically in the set preview frequency (see
Users and User Rights / Preview Frequency
shown in the far right position, it becomes active; the buttons Stop and Skip can be used:
012_start
Note
For capacity reasons, the images in the display have much fewer pixels than the prints
later on. Lack of sharpness can therefore not always be seen in the preview.
6-46
2005-05-01 / PN 04092_01
in this chapter).
in Chapter 4). As soon as the first image is
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Activating a Pint Mode and
Insert the first film strip of the order.
Defining
If you want to print the active image without
further processing: press none of the two
buttons.
If you do not want to print the active image:
press Skip.
If you want to edit the active image press
Stop.
The automatic transport of the preview is
stopped. Buttons are offered which allow
editing of the active image (settings and
possibilities are explained below).
AgfaPhoto
Advertisement
Table of Contents
