Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
4.5.16 Setting TFS Density (only for Color Negatives)
Applies only to d-lab.2/2plus
TFS allows the automatic detection of certain groups of motifs in which a selective
density correction can then be made.
We differentiate five groups of motifs which each have a parameter assigned for separate
control.
Parameter
Function
DL 1
Flash shots (flash portraits or light objects in front of a dark background)
DL 2
High-contrast backlight, snow, or beach shots, landscapes with large parts of a
bright sky
DL 3
Low-contrast snow shots, gray water surfaces with overcast sky, hazy visibility,
etc.
DL 4
Persons with white clothes (e.g. wedding dress) on a green meadow, view through
trees, flowers with a green background, etc.
DL 5
Motifs with a high percentage of blue
Step width:
0.1
Standard setting:
1.0
Higher values always result in darker prints and lower values in lighter prints, i.e. they
reduce the density (individual deviations from the standard value 1.0 are possible of
course!). This applies to all parameters.
Note
We recommend to keep the standard setting of 1.0 for all density parameters, as every
deviation from the standard value of a motif group not only means an improvement for
this group, but also entails a negative effect on other motif groups.
AgfaPhoto
Settings and Configurations
2005-05-01 / PN 04092_01
4
Range
0.0–2.0
0.0–2.0
0.0–1.4
0.0–2.0
0.0–1.4
4-71
Advertisement
Table of Contents
