Initial Pbl And Mbl After The Machine Installation - AgfaPhoto d-lab.2 8060/260 Operation Manual

Tests
5.2.2

Initial PBL and MBL after the Machine Installation

Now the Printer is calibrated for all papers: The production can be started.
We recommend to save the database after a PBL was printed for all papers. By this it is
possible to load the values back into the machine, if necessary,
(see Save and Load Settings and Configurations
5-4 2005-05-01 / PN 04092_01
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Proceed with the following steps:
Use the factory-defined paper configurations
or create the required configurations (see
Defining and Editing Paper Configurations
Chapter 4).
Define the master paper (see
Settings
Usually the machine comes with a factory-
set master paper for the first startup.
After a new software installation without
data transmission from a previous version,
automatically that paper will be entered as
master paper, which is used for printing the
first PBL.
Print a PBL (see
chapter):
Print an MBL (if this was not done
automatically as described above in the
previous paragraph) (see
Test
Print a PBL with laser point for all other
papers to be used. This must be done right
after an MBL was printed, to ensure that the
machine is in the same condition for both
tests.
in Chapter 4).
in Chapter 4):
Check if the settings are correct (see
Printer Settings
in Chapter 4); if
necessary define another paper as
master paper (the most frequently used
paper in the lab).
If the master paper is changed an MBL
will be printed automatically.
Printing a PBL Test
make sure to use the master paper;
activate with laser point.
Printing an MBL
in this chapter).
in
Printer
in this
AgfaPhoto